Manufacturing Engineer - Process Engineer
The Manufacturing Engineer II plans and carries out policies and procedures for manufacturing operation efforts utilized in the manufacturing areas.
*Essential Duties and Responsibilities:*
Under minimal supervision, must be able to perform a variety of job duties including, but not limited to:
- Responsible for and will be the focal point for all technical aspects of assigned project(s) in the following categories:
- Compliance with customer/product procurement specification
- Validate the manufacturing process meets all customer and internal requirements.
- Initiate and support product manufacturability
- Review and support planning document releases
- Advanced Quality Planning (AQP)
- Tooling requirements
- Visual Work Instructions (VWI)
- Meeting cost targets
- Eliminating waste from manufacturing processes
- Responsible for clear and concise work instructions of detail parts, sub-assemblies, and top assemblies.
- Apply operation time standards as required, develop Work Combination Sheets (WCS).
- Ensure the manufacturability of detail parts, sub-assemblies, top assemblies as applicable to projects/programs.
- Potential liaison to provide technical assistance between Senior Aerospace SSP manufacturing and customer cognizant engineering.
- May be assigned to work with developing supplier processes and help correct supplier issues.
- Assist in the initial manufacturing cycle of all new detail parts, sub-assemblies and assemblies for assigned New Product Introduction (NPI).
- Follow up on the effectiveness of manufacturing processes.
- Identify, implement and drive cost reduction ideas. Assigned to special cost reduction initiatives as part of a muti-discipline team.
- Works on or leads a Production Support Team and partners with the other team members to address manufacturing issues.
- Performs Root Cause and Preventive Actions to eliminate causes for nonconforming products.
- Perform, document and validate component, assembly, and/or system processes such as machining, forming, stamping, heat treating, and chemical processing of the following materials:
- Titanium
- Inconel
- Aluminum
- Stainless Steel
- 01 and D2 tooling steel
- Ensure that all engineering changes are documented and implemented.
- Coordinate and support the design of tooling as it applies to the manufacturing/assembly process.
- Develop sound manufacturing processes based upon Senior Aerospace SSP’s capabilities.
- Review production drawing(s) for technical content.
- Make recommendations and offer credible solutions to product, tooling and processes.
- Provides data and relevant information to the quoting process.
- Perform related work as required.
- Follow all Senior policies and procedures.
- Other duties as assigned.
Pay: $80,000.00 - $90,000.00 per year
Benefits:
- 401(k)
- Dental insurance
- Employee assistance program
- Parental leave
- Retirement plan
- Tuition reimbursement
Work Location: In person