Microwave Filter R&D Engineer
Description:
Permanent position for a Microwave Filter R&D Engineer to research, design and develop high-performance passive RF components and assemblies for commercial and defense applications.
Design advanced pseudo-elliptic filters (single- and multi-mode), diplexers, multiplexers and switched filter banks using lumped, planar, cavity and dielectric resonator technologies.
Perform 3D full-wave EM and RF circuit simulation to synthesize, optimize and validate designs.
Lay out RF and DC boards for switched filter banks, including basic amplifier stages and switch bias/control circuitry.
Develop filter synthesis, test and automation software for use by other engineers.
Write acceptance and qualification test procedures and support lab technicians with simulation-based analysis of measured results and recommended circuit changes.
Provide electrical design guidance to the mechanical design team on new products.
Support customer proposals with written and verbal technical presentations.
Participate in design reviews, present papers at technical conferences and contribute to new product development.
Wide range in compensation, depending on experience.
Requirements:
PhD Electrical Engineering or Physics.
Research and design experience focused on microwave filters, diplexers and multiplexers (not antennas, propagation or system-level RF/link budgets).
Experience with filter synthesis and design in both discrete (lumped) and distributed technologies.
Experience with cavity, planar and dielectric resonator filter design, including pseudo-elliptic and multi-mode topologies.
Proficiency with 3D full-wave EM and RF circuit simulation tools (HFSS or similar).
Programming experience for filter synthesis and test automation.
Understanding of driver/bias circuits and basic logic networks for RF switch control.
PCB layout experience for RF and DC boards a plus.
Published papers or conference presentations in microwave filter design a plus.
#ERGx