Upvote
Downvote
Principal Firmware Design - Radar Products (Onsite)
Share Job
- Suggest Revision
- The Principal Firmware Design Engineer is responsible for requirements analysis and decomposition, sub-system design, modeling, simulation, and design verification test.
- Digital Signal Processing and Design: Active noise cancellation, automatic line-enhancement signal processing, Kalman filters, Digital Up/Down Converters, CIC Filters, Polyphase and Half-band Filters, A/D Converters, D/A Converters, DDR, Digital Waveform Generators, Mixed Signal CCAs, Mixed Signal Modules and Subsystems
- Digital Hardware: Subsystem/Module Digital Circuits, FPGA knowledge, COTS Interfaces, High Speed Memory Interfaces, Subsystem Development, VME/PCI/SPI interfaces Digital Systems, System Trades, Architecture, Embedded Processing
- Typically requires a Bachelor's degree in Electrical Engineering or related Science, Technology, Engineering or Mathematics (STEM) degree discipline and a minimum of 8+ years of experience in one or more of the following areas: Digital Signal Processing
- Experienced designing in Matlab/Simulink with DSP Builder and HDL Coder blocksets
Active Job
Updated 4 days agoSimilar Job
Relevance
Active